Wheel
Dresser Features
ELIMINATE
ELABORATE SETUPS
No need to pre-set diamond or use any other tool except a micrometer
and a simple hex wrench. No Gage Block–Master Gage setting–Jo
Block–Parallel Bar–Surface Plate–Height Gage– Dial indicator.
No movement of dovetails necessary to form angles. The angle is
dressed by continuing to push handle in both directions after
radius is formed. No need to use Gibs & V-Ways other than positioning
surfaces.
ACCURATE–RAPID,
REPEAT FORM-DRESSING
Fluidmotion generates clean, precise wheel profiles entirely free
of chatter marks. Without FLUIDMOTION a perfect blend of angles
and radius is improbable.
PRECISE
SHARP CONTOURS
Concave or convex, at a full 180 degrees, are obtained consistently
with 0.0001” accuracy guaranteed.
CONVEX
RANGE
Zero to 3 inches.
If the models desired in this catalog do not answer your particular
grinding requirements, special dressing equipment can be furnished
to your specifications to dress wheels up to 42” in diameter.
CONCAVE
RANGE
1/32” to 3 1/2 inches.
PRECISION
Hold Intersecting angles –12 to 15 seconds. This is accomplished
by operating upright and handle.
SET
UP TIME
Setting up two angles requires 10 seconds. Setting two angles
and radius requires less than 3 minutes.
MOST
DURABLE DRESSER AVAILABLE
Manufactured in the U.S.A. from hardened, ground and lapped alloy
steels. No wear surfaces. Swivels on sealed bearings. |